Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

need help finding the right scope rings

Discussion in 'Rifle Country' started by cemjr, Feb 4, 2011.

Thread Status:
Not open for further replies.
  1. cemjr

    cemjr Member

    Joined:
    May 8, 2010
    Messages:
    274
    Location:
    Michigan
    I have a Noveske N4 low pro 16" ar-15 (flat top). I picked-up a Leupold VX-III 1.5x5 scope, it's a 1" tube. I need to clear the Troy inds. BUIS . The rings/mount will need to measure 1" from the bottom of the tube to the top of the receiver minimum. It would be nice to have it in a one piece QD in case I needed to remove it to use the irons but I don't want to "break the bank" to get this feature. Can I use either weaver or picatinny? I looked at some extreme tacticals made of steel, they weighted a ton! Please help, my eyes are about to fall out from surfing the net!
     
  2. Maverick223

    Maverick223 Member

    Joined:
    Dec 19, 2008
    Messages:
    11,262
    Location:
    28078
    I believe American Defense and Larue both make what you are looking for, but will both cost a good bit. The Burris PEPR or Armalite Mount might also fit the bill, and cost a good bit less (about 1/3 to 50% of the aforementioned), but are not available with the QD feature to the best of my knowledge.

    :)
     
  3. cemjr

    cemjr Member

    Joined:
    May 8, 2010
    Messages:
    274
    Location:
    Michigan
    Thanks, found the burris P.E.P.R that should fit the bill and they now offer it in a QD version.
     
  4. Maverick223

    Maverick223 Member

    Joined:
    Dec 19, 2008
    Messages:
    11,262
    Location:
    28078
    NP, glad you found what you needed.

    :)
     
Thread Status:
Not open for further replies.

Share This Page