Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Need help reassembling SKS trigger

Discussion in 'Rifle Country' started by dubious, Dec 25, 2007.

Thread Status:
Not open for further replies.
  1. dubious

    dubious Member

    Joined:
    Feb 19, 2007
    Messages:
    438
    [​IMG]
    I took apart my sks trigger group to polish the surfaces and replace springs. When I put it back together, if I push down the disconnector rod it releases the hammer without pulling the trigger. I'm not sure if the rebound disconnecter was put back correctly. Should the rebound disconnecter be under the trigger bar? Or should it be on top of the trigger bar with the trigger bar coming up inside of it? Or should it be on top of the trigger bar all together?
     
  2. AZAndy
    • Contributing Member

    AZAndy Member

    Joined:
    May 20, 2007
    Messages:
    1,195
    Location:
    Prescott, AZ, USA
    There are some photos here that might help you.

    A.
     
  3. dubious

    dubious Member

    Joined:
    Feb 19, 2007
    Messages:
    438
    While much appreciated, I already was using that site as reference for my trigger job. Also I was using goldenloki.com which has even more detailed pics. However, I'm unable to find a pic of the part I'm asking about. It takes so much effort to get the spring back on that I really want to get it right. Anybody else?
     
Thread Status:
Not open for further replies.

Share This Page