Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

New AR-15 Build

Discussion in 'Rifle Country' started by HOLY DIVER, Feb 26, 2010.

Thread Status:
Not open for further replies.
  1. HOLY DIVER

    HOLY DIVER Member

    Joined:
    Jan 1, 2008
    Messages:
    1,043
    Location:
    spartanburg,SC
    [​IMG][​IMG]
    Barrel: White Oak Armament 18inch SPR 1/7 twist
    Upper Receiver: Bravo Company M-4 Feed ramps
    Bolt Carrier: Bravo Company
    Bolt: White Oak Armament
    Flash Hider: Vortex
    Gas Block: Daniel Defense
    Handguard: Yankee Hill free float rail
    Scope: BSA

    just got this upper put together last night. i can't wait to get a target pinned up at 500 yards and see how the WOA barrel does!the finish on the BCM upper receiver is very very nice! bolt carrier key is staked great on the BCM carrier. only thing that will most likely change in the near future is the scope i'll prob go with a smaller compact target scope. the lower reciver is not done yet on this rifle so i just have it on a DEL-TON lower that i keep for a spare.
    i'm not done with the lower yet because I'm pretty hung on a good trigger that's as dependable as a stock trigger. I'm thinking LMT 2stage or a RRA 2stage please fill free to wiegh in on this issue i have
     
    Last edited: Feb 26, 2010
  2. Zerodefect

    Zerodefect Member

    Joined:
    Mar 28, 2009
    Messages:
    4,381
    Location:
    Yakutsk, Sakha Republic
    Very nice. The Vortex looks cool on every rifle I've seen it on. Odd looking scope mount.

    Deos the DD gas block clamp on or use set screws?
     
  3. HOLY DIVER

    HOLY DIVER Member

    Joined:
    Jan 1, 2008
    Messages:
    1,043
    Location:
    spartanburg,SC
    just a normal promag riser i just mounted it foward because the scope suites me better mounted foward a bit could not slide the scope much further forward in the rings because the magnification adjustment ring would hit the riser.......not sure the vortex will stay to long i'm thinking about ordering a JP bennie cooly comp
    Clamp on DD gas block
     
    Last edited: Feb 26, 2010
Thread Status:
Not open for further replies.

Share This Page