Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

No windage adjustment

Discussion in 'Gunsmithing and Repairs' started by bratch, Nov 8, 2006.

Thread Status:
Not open for further replies.
  1. bratch

    bratch Member

    Joined:
    Apr 15, 2004
    Messages:
    2,932
    Location:
    OKC
    Isighted in my Mark II tonight and could not get the scope to adjust the windage. The scope is a Weaver Rimfire, the rings are Millett Angle-Loc and the bases are factory Savage. The rifle is shooting 4" left at 25 yards. What can I do?
     
  2. Oldnamvet

    Oldnamvet Member

    Joined:
    Jun 15, 2005
    Messages:
    1,675
    Location:
    Michigan
    Do you mean you ran out of adjustment on the scope? Is the scope in line with the barrel?
     
  3. bratch

    bratch Member

    Joined:
    Apr 15, 2004
    Messages:
    2,932
    Location:
    OKC
    I didn't adjust it the full range but I gave it numerous clicks and it didn't seem to move the POI.

    From what I can tell everything is in line. I did a rough bore sighting by removing the bolt when I installed the scope.
     
  4. jlmurphy

    jlmurphy Member

    Joined:
    Apr 1, 2006
    Messages:
    209
    You can bore sight it on something bright at a distance, move the vert. and hor. adjustments and see if it makes a difference. If not, time for a new scope!
     
Thread Status:
Not open for further replies.

Share This Page