Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

P-11 triger job

Discussion in 'Handguns: Autoloaders' started by ozarkgunner, May 31, 2010.

Thread Status:
Not open for further replies.
  1. ozarkgunner

    ozarkgunner Member

    Joined:
    Nov 11, 2009
    Messages:
    250
    I've looked before, and not found many accesories for the P-11. I found one ad for a triger job, but it only brought it down to 9lbs or so. Does any one know of a good trigger job for the P-11? Preferably just a drop in, do-it-yourself kit. I don't have the money to send my gun off to a gun smith.
    A descent trigger job would greatly increase my accuracy.
     
  2. trekgod3

    trekgod3 Member

    Joined:
    Mar 14, 2008
    Messages:
    246
    Location:
    Jupiter FL
    Check out : http://www.ktog.org/cgi-bin/yabb2/YaBB.pl?board=101

    There's all kinds of good info on the P-11. If I recall, the older P-11 had a heavier trigger pull than the newer ones. I think the old ones were 10 to 11lbs and the new ones are 7 to 8lbs. There are no "drop in" triggers available. There are some mods you can do like the "fluff and buff" and the "paper clip" mod to help a little with trigger pull.
     
  3. Storm

    Storm Member

    Joined:
    Nov 28, 2006
    Messages:
    2,358
    Location:
    Georgia
    If you have any luck with it let us know. I had a P11, wanted to like it, but ended up dumping it due to that trigger.

    BTW, don't waste your money on the trigger shoe.
     
  4. Whirlwind06

    Whirlwind06 Member

    Joined:
    Feb 20, 2006
    Messages:
    540
    Location:
    North East Ohio
    You can find plenty of fluff and buff instructions which will smooth out the pull. A smooth 8 lb pull is really not bad. better then most revolvers.
     
Thread Status:
Not open for further replies.

Share This Page