Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

P3AT Accessory - Rectangular Print

Discussion in 'Handguns: Autoloaders' started by fletcher, Nov 25, 2007.

Thread Status:
Not open for further replies.
  1. fletcher

    fletcher Member

    Joined:
    May 19, 2004
    Messages:
    2,559
    Location:
    TX
    I recall seeing a few months ago an accessory for the P3AT which clips or mounts to the front half of the gun, making it very squarish or rectangular in appearance (to change how it prints in the pocket IIRC). Does anyone know what the name of this is, and where I might find them?
     
  2. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
  3. fletcher

    fletcher Member

    Joined:
    May 19, 2004
    Messages:
    2,559
    Location:
    TX
    It was sort of like the holdster you linked, except it was made of plastic.
     
  4. Green Lantern

    Green Lantern Member

    Joined:
    Aug 16, 2006
    Messages:
    1,665
    +1. When I feel the need, I just slip a few folded sheets of paper between my Desantis Nemesis and the out-facing side of my pocket to 'square' the profile.
     
  5. fletcher

    fletcher Member

    Joined:
    May 19, 2004
    Messages:
    2,559
    Location:
    TX
    I wasn't planning on getting one, as it doesn't print in the Don Hume holster I have, I was just wondering what it was, and who/where sells them.
     
Thread Status:
Not open for further replies.

Share This Page