Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

P95?

Discussion in 'Handguns: Autoloaders' started by pablo45, Jan 25, 2008.

Thread Status:
Not open for further replies.
  1. pablo45

    pablo45 Member

    Joined:
    Apr 28, 2006
    Messages:
    544
    Can you get a single side magazine release for a Ruger P95? By replacing the ambidextrious magazine release on it. I hate the ambi on there now. The magazine always falls out when I put it in the holster IWB.
    Thanks for any help.
     
  2. Firepower!

    Firepower! member

    Joined:
    Jan 3, 2008
    Messages:
    723
    Ruger pistol are made tough, but not sure how they perform and how good are the mechanics of it compare to other high semi autos. Plus you seem to have a pistol which is not right 'fit' for you. Thus, sell it and go to firing range, test a few, and then pick the one you like the best.
     
  3. Blue Brick

    Blue Brick Member

    Joined:
    Sep 23, 2007
    Messages:
    1,452
    Location:
    Pinal County, Arizona
  4. DENALI

    DENALI member

    Joined:
    Dec 13, 2007
    Messages:
    539
    Location:
    Northwestern Wisconsin
    :uhoh: Yeah you probably could have someone pull it off, but at what cost? Just replace the holster or :barf: buy a different pistol.....
     
  5. Whirlwind06

    Whirlwind06 Member

    Joined:
    Feb 20, 2006
    Messages:
    540
    Location:
    North East Ohio
    You can remove the right side mag release.
    Search http://www.rugerforum.org/phpBB there are instruction on there.
    But as somebody else said buy a holster made for the gun and it will not be a problem.
     
  6. Dot_mdb

    Dot_mdb Member

    Joined:
    Dec 24, 2002
    Messages:
    331
    Location:
    FL
    It is possible that the mag release spring is weak. I had that problem on my P-95 and it had to go back to Ruger for replacement.

    Bill
     
Thread Status:
Not open for further replies.

Share This Page