Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

p95dc help

Discussion in 'Gunsmithing and Repairs' started by gaetor, Dec 16, 2007.

Thread Status:
Not open for further replies.
  1. gaetor

    gaetor Member

    Joined:
    Nov 18, 2007
    Messages:
    8
    Location:
    South Florida
    Hello everyone
    My wife and I went to a gun show today and she picked up a new ruger p95dc.
    This is her first gun and I have a GP100. She field stripped it per the manual and cleaned it before taking it to the range tomorrow. When putting it back together. the barrel and recoil assembly must not have been in the correct position. The slide was put back on but the barrel and recoil assembly are sticking out the barrel and I can't get the slide to come back off. If I can get the slide off, then everything can be lined back up. Any help or suggestions would be appreciated.
    John
     
  2. gaetor

    gaetor Member

    Joined:
    Nov 18, 2007
    Messages:
    8
    Location:
    South Florida
    Hello again
    Problem solved.
    john
     
  3. DnPRK

    DnPRK Member

    Joined:
    Mar 30, 2003
    Messages:
    646
    Location:
    LA, CA
    Ejector was in the way
     
  4. gaetor

    gaetor Member

    Joined:
    Nov 18, 2007
    Messages:
    8
    Location:
    South Florida
    DnPrk
    the ejector had been pushed back up. thanks for your response.
    John
     
Thread Status:
Not open for further replies.

Share This Page