Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Part # for Wilson 47D spring?

Discussion in 'Gunsmithing and Repairs' started by mpthole, Jul 25, 2006.

Thread Status:
Not open for further replies.
  1. mpthole

    mpthole Member

    Joined:
    Dec 24, 2002
    Messages:
    1,058
    Location:
    Wisconsin
    I'm looking to replace the magazine spring in all of my Wilson 47D's. The only thing I could find on Brownell's was this part # 969-714-630. Can anyone confirm if this is the correct replacement spring?

    (I need to keep these as 8-rounders for USPSA single-stack division.)
     
  2. Jim Watson

    Jim Watson Member

    Joined:
    Dec 24, 2002
    Messages:
    22,339
    No.
    That spring is for the metal follower 8-round mags like Shooting Star.
    Wolff does not sell springs for Wilson magazines direct, you have to get them from Wilson, even though they are made by Wolff

    I use the ISMI SSCS2
    http://www.brownells.com/aspx/NS/store/productdetail.aspx?p=7541&s=44931
    The Wilson-Wolff deal is so exclusive that ISMI doesn't come out and say that spring fits Wilson tubes, but it does.
     
  3. HSMITH

    HSMITH Member

    Joined:
    Dec 26, 2002
    Messages:
    4,933
    The ISMI is a better spring anyway IMO.
     
  4. mpthole

    mpthole Member

    Joined:
    Dec 24, 2002
    Messages:
    1,058
    Location:
    Wisconsin
    Ok - thanks a ton guys! :)
     
Thread Status:
Not open for further replies.

Share This Page