Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Polish P64 reassembly HELP!

Discussion in 'Handguns: Autoloaders' started by Parke1, Sep 18, 2005.

Thread Status:
Not open for further replies.
  1. Parke1

    Parke1 Member

    Joined:
    Dec 25, 2002
    Messages:
    158
    Location:
    Akron, OH
    Hey folks,

    I recently purchased a Polish P64 from SOG. It's a nice little gun, now that I replaced the hammer spring with a 16lb Walther PP spring. I can actually fire it double action without using both hands now.

    Anyway, I detail stripped the gun last night so I could refinish the slide and frame. The slide went back together just fine, but I'm having a heck of a time figuring out how to reinstall the trigger return spring in the frame. I know I must be doing something wrong, but I just can't figure out how that little jerk goes back in there!

    Any advice would be very helpful. As far as I can tell, no detailed reassembly (or disassembly, for that matter) instructions are available anywhere. I've done more than my fair share of gunsmithing work in my time, but this spring is driving me insane. I've never been stumped by something as simple as a trigger return spring before! HELP!!!

    Thanks,
    -Parke1
     
  2. Parke1

    Parke1 Member

    Joined:
    Dec 25, 2002
    Messages:
    158
    Location:
    Akron, OH
    Also, I know that this trigger return spring system closely mirrors that of a Walther PPK, so if anyone has any experience with that, please let me know!

    Thanks!
    -Parke1
     
  3. eagle45

    eagle45 Member

    Joined:
    Nov 26, 2004
    Messages:
    564
    Location:
    Southwest Ohio
    The folks at makarov.com might be able to help you out. They discuss the P64 there as well as the Mak.
     
Thread Status:
Not open for further replies.

Share This Page