Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

powder & primer storage

Discussion in 'Handloading and Reloading' started by KidDynamo, Jun 5, 2011.

Thread Status:
Not open for further replies.
  1. KidDynamo

    KidDynamo Member

    Joined:
    May 31, 2011
    Messages:
    9
    Location:
    Oregon
    OK, I need to tap into the best-known-methods (BKMs) for storing primers, powders, bullets, and brass. I have 2 kids ages 6 & 7.

    Here are my goals:
    #1 protect my kids & the neighbors' kids
    #2 I reload in my garage, so I'd like to be discrete and avoid dealing with nosy kids
    #3 convenience
    #4 be safe

    I've ruled out using my firearms safe. :cool:
     
  2. Gadzooks Mike

    Gadzooks Mike Member

    Joined:
    Mar 7, 2009
    Messages:
    411
    Build a sturdy, wooden cabinet.(4) Put your stuff in.(3) Lock it with a padlock.(1) When you reload, make sure you have all the doors locked.(2)
     
  3. 45ACPUSER

    45ACPUSER Member

    Joined:
    May 17, 2007
    Messages:
    807
    Location:
    Minnesota
    Well, check your state fire code, as most local cities adopt that. Some states actually limit the # of primers and # of pounds of powder that can be stored in a residence.

    Like Minnesota for one #20 and 10K in primers.

    Cool and Dry are Key Words to live by. Stored Separately. Look in the back or most reloading manuls for help.

    Locked up and and under your control with kids or prying eyes comes to mind.
     
  4. Safetychain

    Safetychain Member

    Joined:
    Jun 24, 2009
    Messages:
    234
    Location:
    Charleston, SC
    I started reloading in the attic; too hot in the summer. Then moved everything to the garage. Everything steel rusted in 2 months (I live on the coast). Then moved everything to the children's playroom. It was "all" the Kids playroom according to the wife. Now with the kids gone it is a reloading, computer, sewing, storage and extra bed room.
    But no matter where I reloaded, all dies, equipment except for the presses, powder and primers went into a Sears style lockable upright toolbox with wheels. They come in all kinds of configurations and drawer sizes. They are expandable/stackable also. Bullets and brass as well as loaded stuff goes into used military ammo cases. They're lockable also and stack well on a shelf or in a corner.
     
  5. Twiki357

    Twiki357 Member

    Joined:
    Jan 26, 2011
    Messages:
    1,906
    Location:
    Prescott Valley, AZ
    I store my powder and primers in a rolling tool chest. Locks secure and in case of a fire, one shove and it's out in the driveway.
     
  6. DANNY-L

    DANNY-L Member

    Joined:
    Sep 9, 2010
    Messages:
    107
    Location:
    Northern,ny
    Teach the kid,s on what could happen to them or others if your stuff was mis-used. I grew up #8 of 9 kids,guns and ammo were all around but no one touched anything until dad taught us and gave us the go ahead that we had learned enough to be safe and responsible, usually by handing us a hunting licence.
     
  7. capreppy

    capreppy Member

    Joined:
    Jan 27, 2011
    Messages:
    619
    Location:
    Fort Worth, TX (Saginaw)
    An interesting tidbit I found out a few days ago. Loose primers (still in the box) are considered HazMat, thus the reason you pay a HazMat fee to have them shipped. Primers that have been inserted into brass are not considered HazMat.

    If you are above your limit for primers, prime some brass to get below your limit. Limits do vary so definitely check with the fire marshall.
     
  8. MtnCreek

    MtnCreek Member

    Joined:
    Dec 8, 2010
    Messages:
    3,954
    Location:
    West GA
    SAAMI has a good publication on storage. Read that then make some adjustments for security.
     
  9. kingmt

    kingmt Member

    Joined:
    Nov 17, 2009
    Messages:
    3,604
  10. gamestalker

    gamestalker member

    Joined:
    Sep 10, 2008
    Messages:
    9,832
    Location:
    SW Arizona
    Since you don't seem to have a room that can be locked, I would build a wooden cabinet and put a hasp on it so you can lock it. If you have to deal with hot or cold elements or humidity, make sure you store those items in the house. My primers are kept in an air tight military ammo box with an oxygen inhibitor in side. The powder I keep on a shelf in the room where it stays at a constant temparature that only varies a couple of degrees.
    With regard to the kids, education is the best answer along with common sense safe guards. All 6 of my children, 5 boys and 1 girl, were raised with trianing and a clear understanding of both firearms and reloading. I never experienced a single problem with them getting into either. Now that they are grown adults they are passing on the tradition and good sense education to my Grand Children.
     
  11. KidDynamo

    KidDynamo Member

    Joined:
    May 31, 2011
    Messages:
    9
    Location:
    Oregon
    Thanks to all ... looks like I'll need to 'secure' the materials very carefully and double check local laws haven't changed.


    KingMt--thanks for sharing your suggestion to use the harbor freight tool chest. Are the drawer sizes adequate for accomodating the powder containers you get at the store?? They looked awfully thin (not tall).
     
  12. Gadzooks Mike

    Gadzooks Mike Member

    Joined:
    Mar 7, 2009
    Messages:
    411
    Maybe this will help:

    http://www.alliantpowder.com/getting_started/safety/storage_handling.aspx

     
  13. amlevin

    amlevin Member

    Joined:
    Jan 15, 2007
    Messages:
    826
    Location:
    NW Washington
    Quickest way to insure that kids will get into mischief is to "Lock them Out".

    This is the best time to introduce them to things like reloading and for that matter, guns. When they are curious, and wanting to learn, take the time to teach them right. In many cases, when their initial curiosity is satisfied, they'll just go on to other things that catch their interest. To keep something "secret" and locked behind doors, will just pique their interest. That one time you forget to lock the door will be the time they explore and without any basic safety cautions the results can be disastrous.

    An informed kid is a lot safer than one kept in the dark.

    BTW, where I live I can store 25,000 primers and up to 50# of powder. Am thinking of getting an old refrigerator for the purpose. A double door model with primer storage in one section and powder in the other to protect both from summer temperatures. Set temps for 50-60 degrees and a couple of large bags of desiccant.
     
    Last edited: Jun 8, 2011
  14. oneounceload

    oneounceload member

    Joined:
    Apr 24, 2008
    Messages:
    15,710
    Location:
    Hot and Humid FL
    Store the powder and primers under heat and air in a constant temperature and humidity state - like the top shelf of a closet.

    Depending on the maturity of your kids and what you are loading, teaching them to reload will take any mystery out of it - mine were taught at 6 as soon as they started shooting.

    I reload in the garage, but here in Florida, it is 10 degrees hotter in the garage, so I have the door open. Folks drive by all the time and most have no idea what I am doing. Lots of folks around here tinker with something in their garages
     
  15. kingmt

    kingmt Member

    Joined:
    Nov 17, 2009
    Messages:
    3,604
    I don't know if that one will or not. They have several different sizes to chose from.
     
  16. kingmt

    kingmt Member

    Joined:
    Nov 17, 2009
    Messages:
    3,604
    I just went & read the specs & you should be able to store the 1#ers in there.
     
Thread Status:
Not open for further replies.

Share This Page