Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Primer sealant?

Discussion in 'Handloading and Reloading' started by bullseye308, Sep 21, 2008.

Thread Status:
Not open for further replies.
  1. bullseye308

    bullseye308 Member

    Joined:
    Nov 24, 2007
    Messages:
    1,386
    Location:
    Smyrna Tennessee
    I was thinking about getting some nail polish to use as primer sealant for long term storage. I may get different colors to keep different loads separate also. How is it used, before or after seating the primer?
     
  2. Maelstrom

    Maelstrom Member

    Joined:
    Jun 3, 2008
    Messages:
    722
    Location:
    HERE
    After. If you use it before you seat it won't seal the primer.
     
  3. brickeyee

    brickeyee Member

    Joined:
    Feb 25, 2005
    Messages:
    3,135
    You might need a little acetone to thin it out.
     
  4. scrat

    scrat Member

    Joined:
    Jan 27, 2007
    Messages:
    6,882
    Location:
    Monrovia, CA
    loctite works well too. just one drop and rotate the shell it will go around the primer
     
  5. brickeyee

    brickeyee Member

    Joined:
    Feb 25, 2005
    Messages:
    3,135
    Only if it can wick in.

    Loctite is an anaerobic adhesive.
    It hardens in the absence of oxygen.
     
  6. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    It's really not necessary in the first place.

    Put your long-term storage ammo in a good GI ammo can and don't worry about it. Moisture can't get through the lid seal.

    The problem with painting primers after they are loaded is, all that paint flaks of inside the gun when you shoot it. Then it gets in the firing pin channel, and other places it shouldn't be.

    Factory ammo with sealed primers has the lacquer applied when the primer is seated.

    If you want to mark different loads, use different colored Magic-Markers.

    rcmodel
     
  7. janobles14

    janobles14 Member

    Joined:
    Apr 22, 2008
    Messages:
    1,095
    i agree with rcm. a while back i did some ammo soaking and never found a single time where the sealant made a bit of difference.
     
  8. matrem

    matrem Member

    Joined:
    Jul 8, 2008
    Messages:
    1,611
    Location:
    Central Ohio
    Years ago,after a "groundhog outing",I forgot about three .223 rounds (no primer sealant) that were in the pocket of my shorts.They went through the Maytag cycle & they "went bang" when I wanted them to.I'd not suggest counting on rounds after going through that,but I've not worried about sealant since.
    Were I in situations where I'd potentially have my rounds under water,I'd use a sealant.
     
Thread Status:
Not open for further replies.

Share This Page