1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Problem cocking Erma EP22

Discussion in 'Gunsmithing and Repairs' started by Autoloader, Jul 14, 2006.

Thread Status:
Not open for further replies.
  1. Autoloader

    Autoloader Member

    Jul 14, 2006
    This Erma is a .22 Luger look alike. The problem is that when the toggle is pulled, the firing pin block(hammer) impacts on the sear and stops.The sear release is preventing the sear from dropping to allow the hammer and bolt to go back and cock. If you pull the trigger, of course then it will cock. But once it releases the hammer it's locked up again. I have a parts illustration and have taken it down several times and all of the parts are in it that should be except the safety lever and ring. I took that out because the lever was damaged and I have another one ordered.
    Thanks for any help.
    Last edited: Jul 16, 2006
Thread Status:
Not open for further replies.

Share This Page