Problem installing IRAS system stem on Tech Sight MINI200 sight

Status
Not open for further replies.

Smiling Bob

Member
Joined
Dec 5, 2007
Messages
32
Location
Cheyenne, Wyoming
I am having a problem installing IRAS stem on Tech Sight MINI200 sight. I just received my Tech Sight MINI200 sight and IRAS system today. Followed directions to remove the fixed aperture stem from the sight and had no problems. Having a hell of a time reinstaling the IRAS aperture stem. What's the trick to getting the stem reinstalled?

Smiling Bob :D
 
If I understand your problem, you have to push the tumbwheel in against a spring & detent ball to center up the threaded hole. IIRC there is pretty good force needed.

I will get one of my tech-sights & see if that is it.

Post back later.
 
WNTFW,

Finally got the IRAS aperture stem installed. Had to hold my mouth right as I simultaneously pushed the elevation dial in with one hand, while turning it with the other hand, and holding the aperture with my other hand. :rolleyes:
In reality I had my wife assist me with holding the aperture stem.

Smiling Bob :D
 
Status
Not open for further replies.
Back
Top