Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Question about Colt MK.V Lawmen?

Discussion in 'Gunsmithing and Repairs' started by krupparms, Dec 16, 2012.

Thread Status:
Not open for further replies.
  1. krupparms

    krupparms Member

    Joined:
    Dec 9, 2010
    Messages:
    1,044
    Location:
    OR. / State of Jefferson.
    Behind the trigger on the bottom of it is a hole w /a hex screw in it. What is it's function? Is it a way to set trigger pull or what?
     
  2. BBBBill

    BBBBill Member

    Joined:
    Mar 7, 2005
    Messages:
    1,839
    Location:
    Alabama and Florida
    If you are talking about a screw in the actual trigger, then no. It is an overtravel stop. I don't recall those being standard on that gun, so probably added by the previous owner.
     
  3. krupparms

    krupparms Member

    Joined:
    Dec 9, 2010
    Messages:
    1,044
    Location:
    OR. / State of Jefferson.
    Thinks, I knew someone would know. That is what it is. Org. owner must have put it there. Think you! Have a happy holidays! Krupp.
     
  4. dfariswheel

    dfariswheel Member

    Joined:
    Dec 26, 2002
    Messages:
    6,117
    The tiny Allen head screw at the rear base of the trigger was adjusted at the factory to limit action movement after the hammer drops.

    It was NOT intended to be changed by the owner.
     
  5. krupparms

    krupparms Member

    Joined:
    Dec 9, 2010
    Messages:
    1,044
    Location:
    OR. / State of Jefferson.
    Thanks! I will not touch it. Thank you for letting me know .
     
Thread Status:
Not open for further replies.

Share This Page