Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Question about determining OAL for a MN M44

Discussion in 'Handloading and Reloading' started by Matt Dillon, Dec 28, 2005.

Thread Status:
Not open for further replies.
  1. Matt Dillon

    Matt Dillon Member

    Joined:
    Jan 4, 2003
    Messages:
    768
    Location:
    Houston, TX
    Folks, it has been awhile since I determined the OAL for a cartridge, and I was wondering if anyone had a good method to do so. I am developing 2 loads for a Mosin Nagant M44 (7.62x54). One for a spire point .311 180 grain bullet, and one for a round nose .311 180 grain bubllet. I have "smoked" the bullet tip with either a candle or a sharpie in the past, then closed the bolt, then attempted to see the rifling on the tip of the bullet, then backed off the oal to be 2-5 thousands of an inch less than that. I have had to repeat this process several times, then average the readings in order to get a good starting OAL. Does anyone have a good method that improves on this? I have gotten bullets stuck in the past, and was wondering if anyone had a better method. Thanks so much in advance!
     
  2. armoredman

    armoredman Member

    Joined:
    Nov 19, 2003
    Messages:
    16,213
    Location:
    proud to be in AZ
    Actually, I just used the reccomeded OAL in the Lee pamphlet. BTW, would you let me know what works well? My Mosin loads kinda bite right now.
     
  3. longrifleman

    longrifleman Member

    Joined:
    Feb 11, 2004
    Messages:
    849
    Location:
    western Missouri
    http://www.surplusrifle.com/shooting/oal/index.asp

    Here is a good description of the procedure. I made my own set-up by buying some nylon bushings and tapping them for standard machine screws instead of buying the stops. I also bought a piece of round stock instead of using my cleaning rod. If I was doing it again I would look around for a brass rod instead of steel.
     
  4. smitty03

    smitty03 Member

    Joined:
    Oct 8, 2005
    Messages:
    33
    Location:
    Washington
    Matt,
    I can't say enough about the Stoney Point OAL gauge I bought for my 223wssm. It made a huge difference! After the results I obtained, I even sprung for the comparator to fine tune even more... I'm not sure if they'll have the proper case for your rifle, but I know you can send them one and they'll modify if for a nominal charge.
     
Thread Status:
Not open for further replies.

Share This Page