Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

R.a.litschert spot shot help please

Discussion in 'Shooting Gear and Storage' started by Darrie, Jul 18, 2009.

Thread Status:
Not open for further replies.
  1. Darrie

    Darrie Member

    Joined:
    Jul 13, 2009
    Messages:
    8
    Location:
    Vernal, Utah
    I took the end off my scope and now can't figure out how it went back togethr. I know it sounds stupid and crazy but I took out a screw to get the lens off and now can not find any hole where the screw goes back. In pictuce 2 that shows about a 3/4 inch slot, could I have turned the lens enough to cover the hole? I have tried to loosen it by hand but can't.

    Thank you,
    Darrie
    Attached Thumbnails
     

    Attached Files:

    Last edited: Jul 18, 2009
  2. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    Well, it seems obvious from the photo the screw head goes in the countersink for it in the rear lens housing.
    And the tip of the screw fits in the slot in the threaded part to keep the lens mount from rotating when you turn it.

    SO, now that the focus, parallax, and seal is screwed, call these guys and see if they will fix it correctly for you.

    http://www.ironsightinc.com/products.html

    It's way too good a scope to be kitchen table screwed with anymore then it already has been.

    rc
     
  3. Darrie

    Darrie Member

    Joined:
    Jul 13, 2009
    Messages:
    8
    Location:
    Vernal, Utah
    Thanks rc,
    I will try the link. And seek the professional help I need.
    Darrie
     
Thread Status:
Not open for further replies.

Share This Page