Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

R3 Recoil Pad

Discussion in 'Shotguns' started by Roadwild17, Dec 6, 2005.

Thread Status:
Not open for further replies.
  1. Roadwild17

    Roadwild17 Member

    Joined:
    Jun 15, 2005
    Messages:
    1,143
    Location:
    Undisclosed
    Does the Remmy R3 Recoil Pad work, simple question?
    Harder question, does it lessen recoil anymore than an average recoil pad?
    Does it work as well as Remington clam it does?

    Thanx,
    Gavin
     
  2. rwc

    rwc Member

    Joined:
    Mar 11, 2005
    Messages:
    596
    Location:
    Bainbridge Island, WA
    I've read that Limbsaver makes them for Remy. I can attest that my Limbsaver pad works.
     
  3. onerifle

    onerifle Member

    Joined:
    Dec 2, 2003
    Messages:
    176
    Location:
    Texas
    +1. Turned my Guide Gun into a Ruger 10/22.

    Well...almost. :D

    Heartily recommended.
     
  4. Darkside852003

    Darkside852003 Member

    Joined:
    Feb 24, 2004
    Messages:
    367
    Location:
    S.E. MI
    I like mine.
     
  5. Dave McCracken

    Dave McCracken Moderator In Memoriam

    Joined:
    Dec 20, 2002
    Messages:
    13,938
    Location:
    MD.
    I've one on my 870 TB. Possibly the best pad I've had for recoil attenuation.
     
  6. ArmedBear

    ArmedBear Member

    Joined:
    Sep 8, 2005
    Messages:
    23,171
    Can I get one (or a Limbsaver branded equivalent; I don't care what it says on it) for my wood-stocked 870 Express 12ga?

    I have looked at specs, and none seem to specify my gun. I believe the Wingmaster has slightly different stock dimensions, for reasons I don't really understand, but hey, what makes sense in the world of sporting gun marketing, anyway?:)
     
  7. pcf

    pcf Member

    Joined:
    May 5, 2003
    Messages:
    862
    Location:
    Arlington, TX
    It might fit, there's quite a bit of variation in the epxress stocks. I put one on my 870 Express Supermag. The pad was a little tall, no biggie. The screws holes didn't line up though. I had to drill the existing screw holes out with a 3/8" drill bit and glue 3/8" wood dowels in their place. Then mark and redrill the holes.
     
Thread Status:
Not open for further replies.

Share This Page