Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Range Report M642-2 125gr Rem Semi JHP

Discussion in 'Handloading and Reloading' started by Slip Shooter, Feb 18, 2005.

Thread Status:
Not open for further replies.
  1. Slip Shooter

    Slip Shooter Member

    Joined:
    Feb 4, 2005
    Messages:
    57
    Location:
    NW Louisiana
    Since my last post, 2-04-05, I have loaded Remington's 125gr Semi JHP in 38 Special with Accurate Arms #2, Bullseye and Win 231 powders for my S&W M642-2.

    I used the Speer #13 Loading Manual page 521 (Non +P loads). Only one load was given for each powder with a Do Not Reduce (DNR) caution. All loads are with Winchester Nickel Brass, Winchester WSP standard primers and a heavy crimp. Charges thrown with Little Dandy rotor powder measure. Chrony Chronograph at 10 feet.



    Results: S&W M642-2 1 7/8 inch barrel

    Powder Charge Velocity Vel Hi/Low Impact on Target (7yds)

    AA# 2 5.4 gr 910 fps 32 fps Point-of-Aim
    AA# 2 5.2 gr 882 fps 19 fps Centered 2 inches low

    Bullseye 4.5 gr 789 fps 26 fps Point-of-Aim

    Win 231 5.6 gr 874 fps 36 fps Centered 2 inches low
    Win 231 5.3 gr 819 fps 33 fps Centered 1.5 inches low

    The 5.4 gr AA# 2 gave best accuracy. All others very worthy groups.



    Here are the results in my S&W M19-5 4 inch barrel

    AA# 2 5.4 gr Not tested
    AA# 2 5.2 gr 933 fps 19 fps point-of-Aim 1" group

    Win 231 5.6 gr Not tested
    Win 231 5.3 gr 931 fps 60 fps Centered 1 inch low 1" gp

    Again the AA# 2 load gave the best accuracy



    I also tested some Winchester 158 gr LSWCHP +P (X38SPD +P)

    S&W M642-2 793 fps 33 fps Shoots Point-of-Aim
    (Carry load)

    S&W M19-5 4" 889 fps 25 fps Shoots point-of -Aim



    In my original post I was concerned about the 125 gr Remington Semi JHP bullet sheading it's jacket in the barrel. I observed no problems in either firearm. the M642's recoil was quite robust right up there with factory loads. Loads were very mild in the M19. I would not reduce loads in the 4 inch M19 more than I have listed. Stay with the Speer Manual for 4 and 6 inch barrels. The Speer # 13 manual is an excellent reference. I have checked several other manuals and considered them all. Speer #13 for me was the way to go.

    For a mild load, I purchased 4 boxes of Aguila 148 gr Wadcutters. They chronographed at 603 fps from the M642 and also shot Point-of-Aim.



    There you have it:

    S&W M642-2
    148 gr Wadcutters for practice
    125 gr Remington Semi JHP for power

    Slip Shooter
     
  2. The Bushmaster

    The Bushmaster Member

    Joined:
    Jan 29, 2005
    Messages:
    7,849
    Location:
    Ava, Missouri
    Slip Shooter. That Mod 19 is a magnum revolver. Boost that W-231 up to 7.6 to 8.0 with that Remington 125 gr SJHP and have some real fun. (you might want to start about 10% below the 8,0 grain). That Remington bullet will not "Shread" it's jacket at the velocities that I send it out of my mod 19 2 1/2". 7.6gr of W-231=1080fps. At 8.0gr of W-231=1130fps And no shreaded jackets. Chronied with a Pact mod 1 at 8 ft. Using either CCI550 or WSPM primers. I load predominately Remington bulk bullets with great success. :D
     
Thread Status:
Not open for further replies.

Share This Page