Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

RCBS gauge pin length ?

Discussion in 'Handloading and Reloading' started by crankincraig, Jan 17, 2009.

Thread Status:
Not open for further replies.
  1. crankincraig

    crankincraig Member

    Joined:
    Jan 15, 2009
    Messages:
    10
    Hi everyone , first post here so go easy on me , been reading here a lot and wanted to post a question. I recently got a RCBS auto progressive press and need to check the adjustment on it. RCBS uses two gauge pins but they do not supply them with the press , does anyone know the length of the two pins? I am a machinest and can easily make them but not sure how long they are. I tried e-mailing RCBS customer service but have not heard from them as of yet , was looking to do this over the cold weekend we are currently having. Thanks in advance for any help.
     
  2. Walkalong

    Walkalong Moderator

    Joined:
    Nov 20, 2006
    Messages:
    48,900
    Location:
    Alabama
    Call them, unless you gotta have them this weekend. They will fix you up. I just talked to them Friday about ordering some more plastic inserts for my hand primer. They are a little loose after 20 plus years. They would not let me buy them, and are sending them no charge. :)
     
  3. rfwobbly

    rfwobbly Member

    Joined:
    Nov 14, 2008
    Messages:
    3,953
    Location:
    Cornelia, GA
    Agreed. If you want action then pick up the phone.
     
  4. crankincraig

    crankincraig Member

    Joined:
    Jan 15, 2009
    Messages:
    10
    Thanks guys , will call.
     
Thread Status:
Not open for further replies.

Share This Page