Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

recommend 243 factory ammo with good brass

Discussion in 'Handloading and Reloading' started by mainecoon, Oct 1, 2013.

Thread Status:
Not open for further replies.
  1. mainecoon

    mainecoon Member

    Joined:
    Feb 25, 2012
    Messages:
    352
    I'm looking for a 50-70 grain factory load that has good enough brass to reload. I'm getting acquainted with my 243 and was going to start off on light loads. Thanks.
     
  2. CarJunkieLS1

    CarJunkieLS1 Member

    Joined:
    Oct 1, 2013
    Messages:
    700
    Location:
    N. Alabama
    Winchester factory loads have been decently accurate out of my .308 and .270 and cloverleaf 3 shot groups out of my wife's Savage .243. Winchester brass is a great brass to reload too.
     
  3. Kurastduuks

    Kurastduuks Member

    Joined:
    Aug 23, 2013
    Messages:
    156
    Location:
    Very rural washington
    I get the best life out of win brass in my bottlenecks. As far as once fired goes you cant get much better IMHO
     
  4. gamestalker

    gamestalker member

    Joined:
    Sep 10, 2008
    Messages:
    9,832
    Location:
    SW Arizona
    I use Winchester, Federal, and Remington probably more than any other's, and all have served well for me. I also like PMC, I have quite a bit left over from the 80's that still has some life left in it.

    GS
     
Thread Status:
Not open for further replies.

Share This Page