1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Redding BR-30 on an LNL

Discussion in 'Handloading and Reloading' started by Walkalong, Mar 8, 2010.

Thread Status:
Not open for further replies.
  1. Walkalong

    Walkalong Moderator

    Nov 20, 2006
    I had previously set my Redding 10X measure up to work automatically on my LNL, but I have been working my BR-30 measure manually. Much slower.

    I finally got around to setting up the BR-30. I made the parts I needed yesterday, and set it up today.

    When I set up the 10X before there a good bit of trial and error going on, since I was starting completely from scratch.

    This time I didn't have to make all the parts, and had some measurements to go by, making things easier. The most critical measurements were the angle of the lift arm and the distance from center the pivot needed to be on the lift arm.


    Attached Files:

Thread Status:
Not open for further replies.

Share This Page