Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Reloading Parts?

Discussion in 'Handloading and Reloading' started by RichardKCMo, May 7, 2009.

Thread Status:
Not open for further replies.
  1. RichardKCMo

    RichardKCMo Member

    Joined:
    Nov 27, 2008
    Messages:
    37
    I have a lee press and a couple of die sets does any other brand interchange rcbs etc.? Richard
     
  2. ants

    ants Member

    Joined:
    Nov 24, 2007
    Messages:
    3,710
    All standard 7/8"x14 dies interchange.


    Dillon dies for the Square Deal B are different.
    Dies for the Lyman 310 tool are different.
    50 BMG are different.
     
  3. RichardKCMo

    RichardKCMo Member

    Joined:
    Nov 27, 2008
    Messages:
    37
    Thanks ,all replys welcome. If i had read Dave's sticky 1st i wouldn't have wasted this space but all info is welcome.
    Richard
     
  4. rfwobbly

    rfwobbly Member

    Joined:
    Nov 14, 2008
    Messages:
    3,953
    Location:
    Cornelia, GA
    All modern 7/8-14 threaded dies will fit, but your best deals are going to probably be Lee dies. Cruise the on-line discounters and you'll see some good prices. These dies are usually ~$25 new and ~$15 used.
     
Thread Status:
Not open for further replies.

Share This Page