Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Remington 1100 Action Spring Tube

Discussion in 'Shotguns' started by Birddog13, May 23, 2006.

  1. Birddog13

    Birddog13 New Member

    Joined:
    Apr 21, 2004
    Messages:
    27
    Location:
    Indiana
    I am wondering if anyone could help explain how someone could change the Action Spring Tube on a Rem 1100. I have the replacement from Remington, but can not figure out how it comes off. Is it a job for a gunsmith?

    Gun was a victom of a break-in. Guy tried to "saw off" the butt stock and when he got down to the action spring tube he could not saw anymore. I bouth the gun cheap and I'm trying to replace.

    Thanks for you help.
     
  2. JohnBT

    JohnBT Senior Member

    Joined:
    Dec 26, 2002
    Messages:
    13,231
    Location:
    Richmond, Virginia
    From www.ahlmans.com

    REMINGTON 1100/ 1187 WORK
    Re-solder original magazine tube $80.00
    Fit/Solder new Mag. tube $110.00(tube extra)
    Solder in new Int. Latch Stud $40.00
    Remove damaged int. latch stud $25.00
    Solder new barrel guide stud $60.00(stud extra)

    Solder action spring tube $50.00 <=<=<=<=<=

    Re-solder loose barrel support $35.00
    Fit/ Solder new barrel support $45.00(support extra)
     
  3. 9mmMike

    9mmMike Member

    Joined:
    Dec 26, 2002
    Messages:
    702
    Location:
    SE PA
    Sure. It's always someone else....... Just kidding. :D Good luck with that repair. I hope the gun was real cheap.

    Mike
     
  4. Birddog13

    Birddog13 New Member

    Joined:
    Apr 21, 2004
    Messages:
    27
    Location:
    Indiana
    Thanks

    Thanks that helps. I was not forsure if it was soldered or dry fit.

    Thanks again
     

Share This Page