Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Remington matte stainless finish....

Discussion in 'Gunsmithing and Repairs' started by BBush, Jan 27, 2012.

Thread Status:
Not open for further replies.
  1. BBush

    BBush Member

    Joined:
    Dec 21, 2005
    Messages:
    62
    I was wondering if anyone has a simple solution on how to fix a small "shiny" rub mark on the matte stainless steel finish of a Remington rifle. As you know, the finish is a matte, but my barrel has a small spot on it where it has rubbed up against something and made the area "shinier" than the adjacent area. If would like to know if anyone has a simple solution to make the area dull again, so that it matches the rest of the finish. If I am not mistaken, the finish is bead blasted at the factory.
     
  2. 7.62X?

    7.62X? Member

    Joined:
    Dec 10, 2011
    Messages:
    18
    Location:
    MN
    I got the same rifle this is what I am going to do. Tap it off and spray paint it flat black then steel wool it back off but leave the black in the pores should look kool
     
  3. rem22long40x

    rem22long40x Member

    Joined:
    Oct 22, 2011
    Messages:
    111
    get a soda blaster from Harber Fraight . it will duplacate the finish .
     
Thread Status:
Not open for further replies.

Share This Page