Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Removing ACE stock

Discussion in 'Gunsmithing and Repairs' started by charles nutinsky, Jul 23, 2006.

Thread Status:
Not open for further replies.
  1. charles nutinsky

    charles nutinsky Member

    Joined:
    Jan 24, 2005
    Messages:
    19
    Looking for instructions on removing an ACE 7” buttstock and replacing it with either a collapsible or fixed buttstock. Especially need advise, instructions regarding removing the ACE already on.

    Thanks for the info.

    Charles
     
  2. rbernie
    • Contributing Member

    rbernie Member

    Joined:
    Jan 21, 2004
    Messages:
    20,557
    Location:
    Norra Texas
    Presuming your Ace is on an AR, disassembly is simple - remove the upper screw in the buttplate/buttpad and wiggle the stock rearward until it disengages from the receiver. Be careful not to lose the rear takedown pin detent spring that's being held into the receiver by the stock.

    The hardest part is going to be finding a way to slide the neoprene sleeve off the buffer tube so that you can remove the stock. I recommend dripping warm soapy water between the buffer and the sleeve.
     
Thread Status:
Not open for further replies.

Share This Page