Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Removing DPMS Flash Hider

Discussion in 'Rifle Country' started by Drakejake, Feb 22, 2007.

Thread Status:
Not open for further replies.
  1. Drakejake

    Drakejake Member

    Joined:
    Dec 31, 2002
    Messages:
    826
    Location:
    Nashville, TN
    I bought my DPMS Panther Lite less than a year ago. It has a flash hider with surfaces for a wrench. I am told that these are merely screwed on and that the threads on the barrel are one-half by twenty-eight. So there is no solder or pin? The FH can be unscrewed with sufficient muscle power? One unscrews this counterclockwise as you are looking at the muzzle?

    Thanks,

    Drakejake
     
  2. Bartholomew Roberts

    Bartholomew Roberts Moderator Emeritus

    Joined:
    Dec 26, 2002
    Messages:
    14,613
    Location:
    Texas
    Assuming that you have a 16" barrel, the flash hider should just be screwed on and can be unscrewed with the appropriate wrench and a little muscle.

    Make sure you don't have a 14.5" barrel with permanently attached muzzle device to bring it out to 16" though.
     
Thread Status:
Not open for further replies.

Share This Page