Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Replacement sights on an Arcus?

Discussion in 'Handguns: Autoloaders' started by GAC, Jan 13, 2004.

Thread Status:
Not open for further replies.
  1. GAC

    GAC Member

    Joined:
    Jan 4, 2003
    Messages:
    87
    Location:
    Southern WI, Madison area
    Does anyone have experience in replacing the sights on their Arcus Hi-Power clone? I'd like to get night sights but am not sure if any brands are an easy fit on an Arcus.

    If milling is required, the price of the work plus the cost of the sights would almost equal the cost of a new gun.
     
  2. railroader

    railroader Member

    Joined:
    Dec 24, 2002
    Messages:
    1,676
    Location:
    az
    If I remember correctly on the arcus I had the rear sight cut was .285" and the front was .280". I put on a LPA adjustable rear and a millet front I did have to rework the slide for the rear sight. Don't know if this helps you any. Mark
     
  3. berto

    berto Member

    Joined:
    Dec 15, 2003
    Messages:
    101
    Location:
    WA
    I keep hearing folks suggest looking at Sig pistol sights as they are supposedly same cut measurements.I have the Arcus 94-have the same problem....:D
     
Thread Status:
Not open for further replies.

Share This Page