Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Replacing grips on Beretta 92, use washers?

Discussion in 'Handguns: Autoloaders' started by McKnife, Nov 30, 2007.

Thread Status:
Not open for further replies.
  1. McKnife

    McKnife Member

    Joined:
    Dec 9, 2006
    Messages:
    168
    Location:
    Texas
    Question... I just replaced the standard grips on my Beretta 92 with Hogue wrap-around grips and I was wondering if I need to use the 'grip washer' with these new grips.

    I tried using the washers at first, but I found it unusually difficult to put the grip screws back in. I took them out and replaced the screws without the washers, and it works fine.

    Am I supposed to use the washers?

    Let me know. Thanks to all.
     
  2. Tang

    Tang Member

    Joined:
    Nov 23, 2005
    Messages:
    42
    Location:
    San Mateo,Ca
    Beretta 92 washers

    As long as the magazine will drop free you should be okay, if not the washers have to go back in.
     
  3. 10-Ring

    10-Ring Member

    Joined:
    Dec 24, 2002
    Messages:
    12,037
    Location:
    California
    On the few I've installed for friends, I did not use the washers
     
  4. Onmilo

    Onmilo Member

    Joined:
    Jul 26, 2004
    Messages:
    9,773
    Location:
    Illinois`
    You shouldn't need the grip screw washers.
    Just make sure you don't overtorque the screws and strip the frame bushings.
     
Thread Status:
Not open for further replies.

Share This Page