Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Replacing Lee primer post and guide

Discussion in 'Handloading and Reloading' started by orrwdd, Apr 2, 2010.

Thread Status:
Not open for further replies.
  1. orrwdd

    orrwdd Member

    Joined:
    Nov 15, 2009
    Messages:
    171
    Location:
    Rigby, Idaho
    The Large Primer Arm for my Turret press fell out and the primer guide (little round cup) the primer sets in got bent and I need to replace the pin and guide with one from a broken primer arm.

    How do I remove the Pin, spring and guide from the primer arm? Do they unscrew and how to do that as it just seems to spin on the spring when I turn it?

    Any help appreciated.

    Bill
     
  2. G36Rick

    G36Rick Member

    Joined:
    Mar 24, 2010
    Messages:
    30
    Location:
    Lake Dallas, Texas
    I would send it back to Lee...I'll bet they fix it,or just send you a new one for free ! Their customer service is fantastic !
     
  3. orrwdd

    orrwdd Member

    Joined:
    Nov 15, 2009
    Messages:
    171
    Location:
    Rigby, Idaho
    They sell the pin and guide as separate parts, I am sure that there must be a way to disassemble and replace these parts and I do have others on hand. Seems a waste to have to wait on a replacement from Lee.

    Bill
     
Thread Status:
Not open for further replies.

Share This Page