Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Reseting zero on Leupold target turrest

Discussion in 'Rifle Country' started by Tosi, Nov 1, 2007.

Thread Status:
Not open for further replies.
  1. Tosi

    Tosi Member

    Joined:
    Sep 15, 2007
    Messages:
    37
    Location:
    Communist sector of USA aka MA
    I have a leupold VX-II tactical with the 1/4 moa target turrets (not the m1 or m3) and I was wondering how I reset the knobs to zero? I know its the set screws but what should I use to undo them, its not very apparent by looking, a small allen wrench???? Thanks mike
     
  2. hksw

    hksw Member

    Joined:
    Dec 25, 2002
    Messages:
    4,157
    Location:
    OH
    A very small Allen-type wrench should have been included with the scope if bought new or converted through Leupold (to add target turrets). The turrets should have three set screws nearly equally spaced around the circumference set in the grooved portion of the turret. loosening at least two should allow you to turn the turret's graduated cylinder but not the adjustments themselves. Once the zero is set, carefully tighten the screws that were loosened.
     
  3. Tosi

    Tosi Member

    Joined:
    Sep 15, 2007
    Messages:
    37
    Location:
    Communist sector of USA aka MA
    Thanks, I got the scope without a box for some reason so I didnt have the hex wrench, but......... I went to put the sling on and got what i thought was a small screw driver from a rc car tool kit only to find out that it was mini hex head which I course tried on the turrets and found it to be the PERFECT size.
     
Thread Status:
Not open for further replies.

Share This Page