Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Revelation 400-C problem

Discussion in 'Shotguns' started by rolltide50, Apr 20, 2008.

Thread Status:
Not open for further replies.
  1. rolltide50

    rolltide50 Member

    Joined:
    Apr 20, 2008
    Messages:
    2
    Hey y'all, I've been lurking on this site for a few weeks now and I figured you guys might be able to give me a little help. The other day my dad asked me to clean his old Revelation model 400-C for him. Everything was going fine til i tried to put the trigger group back into the receiver and it for some reason wont fit back in. Theres nothing inside the gun thats making it stop like it did, it just dosent seem to fit right. Does anybody know of anything i might be able to do? Any help would be greatly appreciated.
     
  2. Ash

    Ash Member

    Joined:
    May 10, 2004
    Messages:
    5,358
    Location:
    Anywhere but here
    This is the same as the Savage 750 or Stevens 740 Aluminum-framed Auto-5 shotguns. You probably will have to fiddle with it, wiggle, jiggle, etc, to get it into place.

    Ash
     
  3. rolltide50

    rolltide50 Member

    Joined:
    Apr 20, 2008
    Messages:
    2
    Ok thats what i was starting to think, cause i finally got the pin halfway in I just have to work on the other side. Thanks for your help.
     
Thread Status:
Not open for further replies.

Share This Page