Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Rifle Refinishing

Discussion in 'Rifle Country' started by SomeKid, May 4, 2006.

Thread Status:
Not open for further replies.
  1. SomeKid

    SomeKid Member

    Joined:
    Aug 25, 2005
    Messages:
    1,544
    Location:
    FL
    I got a CMP M1 recently, and well, the wood looks poor.

    Does anyone know of a good place that I could send the wood to and have it re-done to be better looking? I haven't decided whether or not I actually will, but if the money is there, I almost definitly will.

    Or, instead of refinishing, would it be a better deal to just buy new stocks? I do want to keep it wooden.
     
  2. hoghunting

    hoghunting Member

    Joined:
    Feb 16, 2006
    Messages:
    1,598
    Why not use some elbow grease and do it yourself? Use a stripper that you can get from a hardware store and strip the old finish. Sand the stock until it is as smooth as you want it. Stain. Then put on a finish. It takes some time to do it right, but it is not difficult and is very satisfying.
     
Thread Status:
Not open for further replies.

Share This Page