Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Rossi sac 62

Discussion in 'Rifle Country' started by jrpmma, Feb 14, 2009.

Thread Status:
Not open for further replies.
  1. jrpmma

    jrpmma Member

    Joined:
    Feb 13, 2009
    Messages:
    2
    I have a Rossi 22 model # 62 sac. I have lost the magazine rod and can't find one to order anywhere. I did how ever find A magazine rod for a 62 sa. Will this work ? Any help will be greatly appreciated.





    Thanks,Jeremy
     
  2. crushbup

    crushbup Member

    Joined:
    Mar 11, 2008
    Messages:
    492
    Take a look at Numrich's
     
  3. jrpmma

    jrpmma Member

    Joined:
    Feb 13, 2009
    Messages:
    2
    Thats where I found it for the 62 sa. when I searched for my model it showed up in the parts list, how ever when you click on it it says its for the 62 sa model.
     
  4. crushbup

    crushbup Member

    Joined:
    Mar 11, 2008
    Messages:
    492
    I'm by no means an expert, but that might mean the parts are interchangeable. Hopefully someone else will chime in to give a better bit of advice.

    ETA: You might want to post this in the Gunsmithing and Repairs section; someone over there may have experience with this model.
     
  5. MMCSRET

    MMCSRET Member

    Joined:
    Feb 18, 2008
    Messages:
    2,971
    Location:
    North Central Montana, across the Wide Missouri
    Any full line gun smith has blank stock to make 22 magazine tubes out of. Not difficult and generally not expensive. Some are aluminum and some are brass, a gunsmith should have or can get both.
     
Thread Status:
Not open for further replies.

Share This Page