Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Rounded BHP Trigger Lever

Discussion in 'Handguns: Autoloaders' started by Random Discharge, Dec 27, 2003.

Thread Status:
Not open for further replies.
  1. Random Discharge

    Random Discharge Member

    Joined:
    Dec 31, 2002
    Messages:
    196
    Some time ago I had a gunsmith remove the magazine disconnect safety and install a wide combat trigger on my BHP. He also rounded the trigger and sear lever contact edges to improve the trigger pull. Soon after the trigger failed to engage the sear lever-I suspect because the two rounded surfaces simply slipped past each other. He replaced the sear lever and left it alone, but the trigger lever remains rounded to this day. It's had a few hundred rounds through it since, but I've always wondered if this would become a reliability issue. Any BHP experts out there with an opinion on whether I should replace the trigger lever?

    I've attached a picture to show what I'm writing about - poor quality, but good enough to get the point across.

    Thanks,
    R.D.
     

    Attached Files:

  2. George Hill

    George Hill Member

    Joined:
    Dec 22, 2002
    Messages:
    6,842
    Location:
    Uintah Basin, UT
    If Stephen A. Camp doesn't see this thread, send him a Private Message.
    He wrote the book on the HP.
     
  3. C. H. Luke

    C. H. Luke Member

    Joined:
    Feb 7, 2003
    Messages:
    524
    Location:
    NE
Thread Status:
Not open for further replies.

Share This Page