Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Ruger .44 Magnum carbine maintainence

Discussion in 'Rifle Country' started by khofmann, Dec 22, 2006.

Thread Status:
Not open for further replies.
  1. khofmann

    khofmann Member

    Joined:
    Dec 21, 2006
    Messages:
    3
    Location:
    Port Angeles, Wa.
    A question for youse guys.

    I was trying to dissassemble the bolt and slide of my carbine per the ruger instruction manual but ran into a part discription problem/ Paraphrased as follows:
    ",remove the trigger guard-reciever pin", and" This "pin" is not referenced in the parts list and I do not want to make a mistake and loose something.:uhoh: Does anyone know what the component part number (C-?)is is for this pin, as referenced in the Ruger Carbine component parts list?:banghead:

    Any help is always appreciated
     
  2. DnPRK

    DnPRK Member

    Joined:
    Mar 30, 2003
    Messages:
    646
    Location:
    LA, CA
    Part C-5 joins the trigger guard to the rear of the receiver.
     
  3. khofmann

    khofmann Member

    Joined:
    Dec 21, 2006
    Messages:
    3
    Location:
    Port Angeles, Wa.
    big thanks

    makes sense now that you id'd it. Thanks again
     
Thread Status:
Not open for further replies.

Share This Page