Ruger Barrel Thread Protector

[Barmcd]

My RPR came with a brake and no thread protector. That made using a suppressor a PITA because the only thing I had to protect the threads was the brake. It got to the point that I didn’t shoot with the suppressor.

I tried to get one from Ruger, but they don’t list one for the RPR with my serial number and suggested I look to the aftermarket.

There are hundreds of options, but it took me a little looking to find a thread protector that fit properly. This is from Down Range and cost the princely sum of $12.99. It’s just slightly longer than the threads so it protects the crown a little. The only issue is the finish. I’m thinking of using a flat header paint to get a closer match.

 

[unspellable]

Don't paint it. I think the contrast looks nice.

 

[Show Me]

Brakes are a fashion statement like sneakers.
Looks good. I'm waiting for a long A2 flash hider to come in for a Boomer break replacement.

 

[jobu07]

Don't paint it. I think the contrast looks nice.

I agree, I think it looks sharp.

 

[Barmcd]

Well, I'll leave it as is. Thanks!

 

[bwalker36]

@Barmcd Which one did you get, the bull barrel one that is .750 in length?

 

[Barmcd]

@Barmcd Which one did you get, the bull barrel one that is .750 in length?

5/8" x 24 Thread Protector .625 Long .860 Dia. Black Oxide #4265​

 

[Shawn Dodson]

Try an M16A1 flash suppressor and split washer. It goes on hand tight and doesn't need to be clocked.