Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Ruger Mark II help :(

Discussion in 'Gunsmithing and Repairs' started by PBIR, Dec 13, 2004.

Thread Status:
Not open for further replies.
  1. PBIR

    PBIR Member

    Joined:
    Jul 5, 2004
    Messages:
    424
    Location:
    Middle TN
    Anyone know how to put a sear spring in?. We have a rental Mark II at the range and I need to get the sear spring in that was handed back to me by a rentee (along with a few other misc. pieces). Anyone have any idea where I can find a pic of it properly seated? Thanks in advance.

    Dan
     
  2. Kruzr

    Kruzr Member

    Joined:
    Dec 30, 2002
    Messages:
    1,041
    Location:
    Surf City, PRK
    yzguy's site will answer the question.
    yzguy's ruger mark 2 site instructions
    Here are pics from his site: Long leg goes down and under the pin in the frame.

    dcp02166.jpg

    In place:
    dcp02168.jpg

    (Thanks to yzguy)
     
  3. PBIR

    PBIR Member

    Joined:
    Jul 5, 2004
    Messages:
    424
    Location:
    Middle TN
    Once again the knowledge base here amazes me. Thanks for the rapid help!

    Dan
     
  4. Standing Wolf

    Standing Wolf Member in memoriam

    Joined:
    Dec 24, 2002
    Messages:
    24,041
    Location:
    Idahohoho, the jolliest state
    One hopes the individual was at least suitably embarrassed.
     
Thread Status:
Not open for further replies.

Share This Page