Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

S&W 1000 Shotgun Disassembly

Discussion in 'Gunsmithing and Repairs' started by rbernie, Sep 25, 2006.

Thread Status:
Not open for further replies.
  1. rbernie
    • Contributing Member

    rbernie Member

    Joined:
    Jan 21, 2004
    Messages:
    20,450
    Location:
    Norra Texas
    Can anyone tell me how to get the mag reducer pin and mag follower out of the magazine tube on a 12GA S&W/Mossberg 1000? I've figured everything else out but those two items.

    I just picked up a nice 1000 that sadly had the rubber gas piston buffer thingee solvent-melted all the way down the magazine tube.... :banghead:
     
  2. Clemson

    Clemson Member

    Joined:
    Feb 17, 2003
    Messages:
    641
    Location:
    Greenwood, SC
    Quote from The Gun Digest Book of Firearms Assembly/Disassembly Part V: Shotguns:

    "It is possible to spring the magazine spring retaining washer out of its detent holes at the front, allowing removal of the spring and follower. Unless necessary for repair, though, this system is best left in place. If removal of the magazine tube is necessary, unscrew the tube retaining nut at the base of the tube, and unscrew the tube from the receiver. The capacity reducing pin, which serves the same purpose as a plug, can be removed by driving it out toward the right."

    Clemson
     
Thread Status:
Not open for further replies.

Share This Page