S&W repair issue.

Discussion in 'General Gun Discussions' started by Xcobra122, Mar 10, 2020.

Thread Status:
Not open for further replies.
  1. Xcobra122

    Xcobra122 Member

    Joined:
    Nov 18, 2019
    Messages:
    35
    Hello all, I recently sent my M&P9c in for warranty repair. There was some unexplained damage to the part of my slide that pushes the trigger bar out of the way during cycling. It had a great trigger before I sent it in, but they replaced the slide and now my trigger is extremely gritty, especially right before the break. Is there anything I can do to fix it myself? I really don't want to send it back in for another 2 month wait.
     
  2. Ks5shooter
    • Contributing Member

    Ks5shooter Contributing Member

    Joined:
    Dec 16, 2013
    Messages:
    2,424
    Location:
    Communist state of nj
    If it was an aftermarket trigger they will remove it and make it stock before returning to you. Liability issues.
     
    ApacheCoTodd likes this.
  3. Xcobra122

    Xcobra122 Member

    Joined:
    Nov 18, 2019
    Messages:
    35
    It was a stock trigger to begin with and all they replaced was the slide.
     
    Ks5shooter likes this.
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice