Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Savage Mark II extractor replacement

Discussion in 'Gunsmithing and Repairs' started by highway, Apr 5, 2004.

Thread Status:
Not open for further replies.
  1. highway

    highway Member

    Joined:
    Oct 23, 2003
    Messages:
    12
    Location:
    KY
    Hello,
    I ordered right/left hand extractors form Savage to replace the ones on my savage mark II -bolt action- 22lr. I bought the rifle used and noticed the extractors wasn't working just right, i recieved the new ones today and the right and left had different part numbers but no #'s are stamped on the extractors. I installed the new pieces along with a new extractor clip and it works fine but i was wondering about the right hand -left hand numbers? how would i tell the difference between the 2 ? they looked the same unless the small hook at the end has a different pitch or something ?

    thanks highway
     
  2. 1911Tuner

    1911Tuner Moderator Emeritus

    Joined:
    May 22, 2003
    Messages:
    18,550
    Location:
    Lexington,North Carolina...or thereabouts
    Savage

    Howdy highway, and welcome to THR.

    Your best bet is to PM a fella named Jim Keenan here. You can do a search
    on his name. He may see your question later on today, but if anybody'd know, he would.

    Where at in Kentucky? I was born in Southeastern Ky, in "The Little Town That International Harvester Built", in Harlan County...also known as
    "Bloody Harlan."

    Luck!

    Tuner
     
  3. highway

    highway Member

    Joined:
    Oct 23, 2003
    Messages:
    12
    Location:
    KY
    1911Tuner,
    i spoke with savage and i ordered the wrong part , needed the right hand extractor and silver color cartridge guide to go on the left side. so hopefully i will get it this time around :)

    Oh yeah....I'm from pike county KY

    highway
     
Thread Status:
Not open for further replies.

Share This Page