Seafoam

Status
Not open for further replies.

0ne3

Member
Joined
Nov 22, 2014
Messages
177
Not sure where to put this. I have heard of some people gleaning there firearms with Seafoam. I never heard of this before, has any one else? What do you guys think about this?
 
I have some smoking pipes made out of it, but never thought of it as having any other purpose. I'll keep an eye on this thread to see what's what.
 
ATF + mineral spirits + kerosene is Ed's Red without the acetone. Cheaper than Seafoam and probably a better mix of solvents.

There's nothing magical about Seafoam. It's just a mix of petroleum solvents. ATF alone is a darned good cleaning solvent at 1/3 the price.
 
Not sure where to put this. I have heard of some people gleaning there firearms with Seafoam. I never heard of this before, has any one else? What do you guys think about this?

The best firearm is a gleaned firearm.

Keep your gun decently lubricated and cleaning is super easy. Use what you want. Soak if you have a coked bolt or gas operated mechanism.
 
Sea Foam is a great cleaner for getting carbon deposits off of parts. I've used it for years. Another product that works for carbon cleaning is Mercury Quicksilver.
 
About the best general gun cleaner I've come across is just plain old Xylene-----and at about $12-15/gallon, it is much, much, cheaper on a per ounce basis than Sea Foam.
 
Seafoam is a petroleum distillate, and because of it's molecular structure, you can pour a pint of it into a quart of oil and it fits in between the larger oil molecules. It will not overfill the container.

That makes the structure a lot smaller than most distillates, and why it works as a good solvent in contact with burned hydrocarbons. At retail it's $8 a pint. There are far more economical solvents that will do the same job. Even good ol CLP will clean a gun.
 
I use Sea Foam as a fuel additive in outboard motors because ethanol in gasoline can cause carburetor problems when gas is stored. I believe it consists of pale oil, naphtha, and isopropyl alcohol.
On guns? I might use it as a bore cleaner if I was out of #9, but not as a general lubricant or rust preventative.
Tinpig
 
I spray Seafoam into my carburetor to fog my boat inboard engine. I think it prevents the insides of the carb and cylinders from getting any corrosion over the winter.
 
It's basically good old fashion Ethyl alcohol. I use when I store gas over the winter. I'm not to sure about using it as a gun cleaner.

They were discussing the ingredients of Seafoam on a boating site I watch. One of the posters tested it and said it was "good old fashion Ethyl alcohol". BTW it does help the performance of my outboards and ATVs.
 
Status
Not open for further replies.
Back
Top