Quantcast

Seecamp Chamber Pictures?

Discussion in 'Handguns: Autoloaders' started by Badger Arms, Oct 19, 2016.

Thread Status:
Not open for further replies.
  1. Badger Arms

    Badger Arms Member

    Joined:
    Jan 1, 2003
    Messages:
    3,738
    Location:
    Harnett County, NC
    I've read enough about this Seecamp chamber ring delay system and I was wondering if anybody had a good picture of the chamber that showed the raised area?
     
  2. usp9

    usp9 Member

    Joined:
    Dec 17, 2005
    Messages:
    3,880
    Location:
    Bowling Green, Va
    Perhaps the Seecamp Forum would be a good place to ask this question. I don't have a photo of the chamber, but I can say that the "ring" is quite faint and as far as I can tell is on the lower half only.
    http://www.seecamp.com/cgi-bin/yabb2/YaBB.pl

    Here's the explanation from Larry Seecamp as quoted from the Seecamp Forum...
    "As for blowback semi autos of the LWS.32 type, the general rule is the heavier the slide the faster the bullet.

    If we totally eliminate friction, the slide speed and bullet speed will be in direct relation to their respective weights.

    To compensate for the light slide on our pistols we put in the chamber ring to retard slide movement. By slowing the slide, we increase bullet speed.

    It's good for the gun and it's good for ballistics."
     
    Last edited: Oct 19, 2016
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice