Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Shortening a Hogue Stock

Discussion in 'Rifle Country' started by deolexrex, Dec 15, 2009.

Thread Status:
Not open for further replies.
  1. deolexrex

    deolexrex Member

    Joined:
    May 2, 2006
    Messages:
    166
    Location:
    Central, IL
    I have a Hogue stock for my main Ruger 10/22 but I would like to shorten the length of pull by 2 inches. Anyone have experience with this procedure?
     
  2. steveracer

    steveracer Member

    Joined:
    Jun 10, 2005
    Messages:
    1,554
    Location:
    VA Beach
    I have shortened the hogue shotgun and rifle stocks many times. Here's the trick:
    Remove the pad, fill the stock with epoxy (bondo works fine, too) and let it set up. Then mark the place you wish to cut by wrapping the stock in masking tape, and making your line on that. If you have a bandsaw, it's REALLY easy, but I don't, and used a folding saw. When it's cut, measure the rear of the stock, and go on Pach-mayr's website and get a pad pre-fit for the dimensions of your cut. When you get it, mark the holes, drill, and add screws. Done. Perfect fit, and costs only whatever the recoil pad goes for. It won't matter much what kind of pad you get for the 10/22, but on the 870, the pad makes a difference.
     
  3. deolexrex

    deolexrex Member

    Joined:
    May 2, 2006
    Messages:
    166
    Location:
    Central, IL
    How much weight will that add to the stock?
     
  4. steveracer

    steveracer Member

    Joined:
    Jun 10, 2005
    Messages:
    1,554
    Location:
    VA Beach
    A bit. In my youth model seven in .260, it balanced it out a little better. I cut another inch off the youth stock, and now it's a 12" LOP.
     
Thread Status:
Not open for further replies.

Share This Page