Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

SIG GRevolution question

Discussion in 'Handguns: Autoloaders' started by kestak, Feb 1, 2009.

Thread Status:
Not open for further replies.
  1. kestak

    kestak Member

    Joined:
    Jul 22, 2007
    Messages:
    1,345
    Greetings,

    I think my SIG 1911 Revolution has a little issue:

    1 - Full cock, safety off, press the beaver tail safety, press the trigger: hammer goes down
    2 - Full cock, safety on, press the beaver tail safety, press the trigger: hammer does not go down
    3 - Half cock, safety off, press the beaver tail safety, press the trigger: hammer goes down!!!
    4 - Half cock, safety on (in fact, it is half engaged), press the beaver tail safety, press the trigger: hammer does not go down
    5-Half cock, safety off, -->does not press the beaver tail safety<--, press the trigger: hammer does not go down!!!!
    6 - Sometimes, in case 4 or 5 the hammer does not go down.

    "In the page 7 of the manual, they write: The safety intercept notch is a passive safety device that prevetns the hammer from falling if the primary sear notch dails....Using the safety intercept notch as a half cock position is a misuse of this feature and can result in untentiooanl discharge"

    I just want to be sure, this is normal behaviour what I described in the 6 points. Right?

    Thank you
     
  2. The Lone Haranguer

    The Lone Haranguer Member

    Joined:
    Jul 30, 2006
    Messages:
    11,717
    Location:
    Johnson City, TN
    That sounds normal to me.
     
Thread Status:
Not open for further replies.

Share This Page