Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Sig grip ?

Discussion in 'Handguns: Autoloaders' started by rgw543, Nov 1, 2007.

Thread Status:
Not open for further replies.
  1. rgw543

    rgw543 Member

    Joined:
    Jul 4, 2007
    Messages:
    9
    Going to buy a Sig soon i have gone forth and back between p220 .45 or p229 .40 i finally decided on the p220 untill i handled both again for about the 50th time[unable shoot either] the p229 fits my hand perfectly..the p220 fits ok front to back but does not fill my hand as well side to side if that makes sense
    my question is i have seen pics with some kind of rubber wrap around the grip..can you tell me what they are and would that increase the girth of the grip? it looks pretty cool also
     
  2. The Lone Haranguer

    The Lone Haranguer Member

    Joined:
    Jul 30, 2006
    Messages:
    11,717
    Location:
    Johnson City, TN
    Is this what you're looking for?

    hogue_sm.jpg
    http://www.pistolgear.com/prodimages/hogue_sm.jpg

    That is a Handall Grip Sleeve, made by Hogue Grips. It should give you the extra width (aka a "palm swell") you desire, but at the cost of an increased trigger reach, which is a bit long already on that gun.
     
  3. rgw543

    rgw543 Member

    Joined:
    Jul 4, 2007
    Messages:
    9
    thank you
     
  4. chris in va

    chris in va Member

    Joined:
    Mar 4, 2005
    Messages:
    6,097
    Location:
    Louisville KY
    I recently 'discovered' my HandAll sitting in my drawer from when it was on my Ruger 22. Somehow I made it fit the Sig 220. Sure fills out the grip, that's for sure!

    [​IMG]
     
Thread Status:
Not open for further replies.

Share This Page