Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Sig P226 9mm to 40 S&W Conversion

Discussion in 'Gunsmithing and Repairs' started by trace009, Mar 25, 2006.

Thread Status:
Not open for further replies.
  1. trace009

    trace009 Member

    Joined:
    Mar 25, 2006
    Messages:
    2
    Is it possible to convert a Sig P226 9mm to a configuration that would allow me to shoot 40 S&W and 357 Sig? If so what parts would I need, about how much do you think they would cost, and where's a good place to get them?

    Thanks!
     
  2. JNewell

    JNewell Member

    Joined:
    Oct 1, 2003
    Messages:
    2,714
    Location:
    Land of the Bean & the Cod
    I don't believe it's possible to cross from 9x19 to .40/.357. You can convert .40 to .357 and vice versa, but the 9x19 guns have a fundamentally different slide. If it were possible to convert a 9x19 pistol, you'd need a whole new top end, which would cost you so much that you might as well buy a new pistol.

    Note that you can cross from .40/.357 to 9x19 via a conversion barrel.
     
  3. trace009

    trace009 Member

    Joined:
    Mar 25, 2006
    Messages:
    2
    Thanks!
     
Thread Status:
Not open for further replies.

Share This Page