sjohns,
More like what do you want?
Have ribbon, have wire at .070, not much of that, a little 1/16, VERY little, a good bit of .093 wire, some .050 X .125 flat "wire", lots of ribbon, 1/4 by .005, .010, 1/2 by .005, .010. Inch and wider by .005 and .010 ribbon. 1/8 by 1/8 stick, though, when I was about ready to send to a refiner, I cut all those sticks into easier to pack pieces, about 6 inches long.
Coupons, precut pieces, 1 1/4 by 4 1/2 by .010, .005 by 1/4 and 3/8 by 1 1/2, same for thickness.
Most is EZE 45, some is Sil-Phos, but that is the stick stuff, and some of the other.
Let me know what you want. Will try to give you what you want.
Let me tell you, under a pound, I can fit in what I have been told is a 1 pound priority mail box for 4.55. Over a pound, I guess an 8.10 Flat Rate box would be best.
I have a pretty accurate scale, but do not hold to the ounce, ie, don't clip that last inch off to get it down to the asked for weight.
If that is okay with you, call me back. I'll talk with you.
Cheers,
George
Sorry, I don't know the temps for EZE 45, will have to check. It is NOT low. Requires alloying agents with low melting point to reduce the temp. Whether they reduce the strength or not, go to Handy and Harmon to see.