Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

single piece scope mount for Stevens 200

Discussion in 'Shooting Gear and Storage' started by Shurshot, Oct 20, 2012.

Thread Status:
Not open for further replies.
  1. Shurshot

    Shurshot Member

    Joined:
    Nov 5, 2010
    Messages:
    109
    Location:
    Ohio
    I am trying to help a friend mount a NV scope to his Stevens 200 .223 rifle. The scopes mounts on any standard Weaver rail. It will mount to the existing factory rails but sits too low to allow the bolt to open. I am looking for the mount in this picture which should work fine. I can't find it on thier website and will have to call them unless someone can tell me where I can find this mount. thanks

    [​IMG]
     
  2. JohnBT

    JohnBT Member

    Joined:
    Dec 26, 2002
    Messages:
    13,232
    Location:
    Richmond, Virginia
    I believe all you need is one to fit a Savage Model 10.
     
  3. greenhornet-1

    greenhornet-1 Member

    Joined:
    Nov 23, 2011
    Messages:
    7
    Location:
    appomattox va
    EGW makes a mount very simaler to that.
     
  4. helotaxi

    helotaxi Member

    Joined:
    May 23, 2009
    Messages:
    2,218
    EGW, Weaver, Warne, Badger Ordnance, Ken Farrell and about a dozen others make rails for the Savage/Stevens. Non one lists the Stevens as a model that it fits, but the Stevens receiver is identical to the Savage and the parts are interchangeable.
     
  5. Shurshot

    Shurshot Member

    Joined:
    Nov 5, 2010
    Messages:
    109
    Location:
    Ohio
    thanks for your comments. I have never owned a Stevens and couldn't find the parts listed but if it is the same as a Savage, it makes it easy. I appreciate the info.
     
Thread Status:
Not open for further replies.

Share This Page