Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Sling studs 982

Discussion in 'Shotguns' started by BullFrawg, Mar 17, 2013.

Thread Status:
Not open for further replies.
  1. BullFrawg

    BullFrawg Member

    Joined:
    May 2, 2012
    Messages:
    27
    Location:
    Casper, WY
    Hey all, I just bought a Hawk 982 shotgun, and I am looking for advice on what sling studs I need to get for it. The back one is just a standard machine thread, but the magazine cap is confusing me. There is a hole in it, but it isn't threaded. Can I just get a standard stud and put a nut behind it, or will that interfere with the magazine follower? Thanks in advance.

    FYI, the 982 now comes with a plastic trigger guard.
     

    Attached Files:

  2. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
  3. Fred Fuller

    Fred Fuller Moderator Emeritus

    Joined:
    Mar 26, 2004
    Messages:
    21,221
    Location:
    AL, NC
    Some of the Norinco/Hawks come from the factory with a shortened machine screw stud in the mag cap, backed by a washer and nut, held in place with a dollop of something like thread locker. Any similar approach should work...
     
  4. BullFrawg

    BullFrawg Member

    Joined:
    May 2, 2012
    Messages:
    27
    Location:
    Casper, WY
    Thanks. These posts are very helpful.
     
Thread Status:
Not open for further replies.

Share This Page